![]() The flex tape sealed the hole underwater! To my shock, it stopped the leak completely! No water trickled through the gap at all. Then, I removed the plastic allowing the water to flow, and hurriedly applied a strip of flex seal underwater to cover up the hole. I then filled the bucket up with water while holding a small piece of plastic on the outside of the hole to prevent all the water from gushing out. The flex tape infomercial features leaking PVC pipes being repaired by a hand slapping section of tape to the outside, which seems unlikely to work in a real-life home repair scenario.įor the last test, I figured I’d test one of the more outlandish claims in the flex tape infomercial – the ability to use it underwater! This was by far the most challenging test to perform, as I wanted to emulate sealing off a water leak while it was actively flowing.įor this test, I drilled another 1 ¾ inch hole in a 5-gallon bucket. ![]() I’d consider this a marginally successful test, as it worked well when both sides of the PVC were taped. This time the repair held back the water and prevented any leaks from developing. Once I had the tape applied to both sides of the pipe, I once again filled it with water. This was actually a little difficult to do, as applying the flex tape inside a 2” wide section of PVC is an exercise in patience and hand-eye coordination. Keep in mind tape was only applied to the outside of the PVC pipe, so I figured I’d try the test once again with flex tape applied to both sides. I tried to fix it by applying pressure with my hand, but the leak continued to flow. This time a small trickle of water began to leak through the tape rather quickly. Then I applied flex tape to the outside of the pipe, sealed off one side with an end cap, and began to fill the other end with water. I started by drilling a couple of small holes into a section of 2 inch PVC pipe I had lying around. The next test I performed was intended to simulate repairing a leaky or damaged section of PVC pipe in your home. I performed this test about 5 minutes after applying the tape, so there was no long curing period involved. There was no leaking whatsoever, and the tape held the water back completely. The bucket repair worked surprisingly well. To my surprise, the tape did its job perfectly. The manufacturer recommends applying the tape to both sides of a repair, which I noticed many users who were having issues weren’t doing.Īfter smoothing out the flex tape to remove any air pockets, I filled the bucket with water above the level of the repair. I then patched it with flex tape both on the inside and outside of the hole. I started with a standard 5-gallon bucket and drilled a 1 ¾” sized hole in it using a hole saw. The infomercial features several examples of sealing leaking holes in plastic containers, so this seemed like a logical place to start. For the first test, I decided to test how well flex tape would work at sealing a large hole in a plastic bucket.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |